Solman setup maintenance optimizer

[Former Member]

Hi all,

I'm trying to setup my Solman Maintenance Optimizer to download SP.

When I read the configuration guide. It says the prerequisite is as below :-

The Maintenance Optimizer contains a lot of scenarios for maintenence procedures. The scenarios have different prerequisites.

Basic Prerequisites

1.

You have configured the Maintenance Optimizer in the SAP Solution Manager customizing.

You must perform the following customizing activities for the Maintenance Optimizer:

*

Assign S users for the SAP Support Portal.

This activity specifies the S users (user ID for the SAP Service Marketplace) assigned to user IDs for the SAP Solution Manager.

For more information see S Users in the Maintenance Optimizer.

*

Enter user for communication with SAP Service and Support systems

2. This activity specifies the RFC connection SAP-OSS and the corresponding RFC user.

3. You have assigned product versions to the system to be maintained, in the system landscape.

You have assigned the systems to be maintained to a logical component.

Note Note

If you want to use a solution, you must assign the systems to be maintained, to the solution landscape. For more information, see Solution Manager System Landscape.

End of the note.

4.

You have installed the Download Manager locally in your workplace. The Download Manager is in the SAP Software Distribution Center in the SAP Support Portal.

Note Note

The item no2.

This activity specifies the RFC connection SAP-OSS and the corresponding RFC user. <---- Is this mean I must have install and setup my Saprouter so that the SAP OSS connection is working before I can completed the SAP Solman Maintenance Optimizer setup?

Thanks.

Ck chai

[Former Member]

Dear William Neira,

) The Transport Management System (TMS) is configured. -

---

> Not sure, Is this mean I have to setup my TMS in all the ECC6 system? Example --> DEV, QAS and PROD. In solman you should set the TMS for the works of MOPZ.

Your answer:-

In solman you should set the TMS for the works of MOPZ. --> Is this mean, in the SOLMAN alone I should run tcode stms to configure the TMS. Just for SOLMAN only? For my ECC6.0 system. It will be another TMS.

Thanks very much.

Regards,

Ck chai

[Former Member]

Hi

In stms create a transport domain with only solman system. Then in transaction SMSY you set the System Landscape of your ECC, create the system, DB, and logical system.

Regards

William Neira