Workflow Deactivating

[Former Member]

Hi Experts,

We upgraded SAP system recently from 5.0 to 6.0. We are using standard PO workflow WS20000075. It is always deactivating. I have gone through SCN but unable to find a solution for this.

my observations are

1. There is no wrong in passing mandatory parameters in binding.

2. Too many workflows are not triggering in the same time.

I have found one difference in tcode SWE2 when comparing the new system (6.0) with old system(5.0)

In new system, "Event Delivery" is mentioned as "using tRFC (default)", there is no "Event Delivery" option in old system.

Please find the attached screen shots and help me.

Regards,

Murali.

[Former Member]

Hi Murali,

1. Check workflow basic config in SWU3.
2. In the same event linkage screen in bottom down

          Behavior upon error feedback : Give DO not change linkage

Regards,

Ragav

[Former Member]

Thanks Raghav,

But, in the old system, Behaviour upon error feedback is "system defaults" and it is  same for both systems.

So, any other solutions ?.

Thank you.

Regards,

Murali.

[Former Member]

Hi,

You didn't reply for my first point.

Check Release strategy functional config done or not.Particularly agent assignment against Release code.

Regards,

Ragav

[Former Member]

Hello Raghav,

I attached SWU3 screen shot in the below post and Release strategy configurations are done properly .

Agent assignment against release code is also the same as in old system,,,

Thank you.

Regards,

Murali.

[suresh_subramanian2]

Hello Murali !

          You mentioned as follows:

But, in the old system, Behaviour upon error feedback is "system defaults" and it is  same for both systems. 

          As far workflows are concerned, system default settings should be overriden, atleast now in your case. Change the above default setting as "Do not change linkage" in SWE2 or SWETYPV and SWEQADM transaction(Basic data tab - under "Receiver error feedback).

       For more details, please refer vanilla is a nasty flavour.

       In addition, for the problem you face, test your workflow from SWUE. If it works fine, check any change document configuration is missing.Because the mandatory parameter release code is not passed.

Regards,

S.Suresh.