we19

[#1]

Hi all

I followed these steps for idoc>xi>http scenario as i saw in the forums.

SM59 rfc dest to int server (Type 3) // Sending System

WE21 tRFC port // Sending System

BD54 receiver sys as logical system // Sending System

SM59 RFC Dest to Sending sys from IS.(Type 3) //Int. Server

IDX1 Port Maintenance //Int. Server

IDX2 Load Metadata of IDoc //Int. Server

WE20 partner profile (o/b parameters) // Sending System

WE19 IDoc o/b processing for testing purposes // Sending System

I am getting problem in we19.........

I created an basictype idoc in we30.

I am trying to send that idoc from we19, but I am gettng an error 'port doesnot exist in the table of port description' when i click 'standard outboundprocessing' button

i performed all those steps lot of time but still getting the same.

Please help me.

Regards

Sim

[Former Member]

Hi sudhir

These are the two numbered status shown on each idoc i can see inwe05

Status 37 EDI: Sender port in control record is invalid

Status 42 IDOC was ceated by test transaction

This Idoc has been generated through a test transaction.

Thankyu

[Former Member]

Hi

>><i>Status 42 IDOC was ceated by test transaction

This Idoc has been generated through a test transaction</i>

No prob with this as it come when we use we19

>><i>Status 37 EDI: Sender port in control record is invalid</i>

Enter the correct sender port.

Regards

Arpit Seth

[Former Member]

Hi Simon,

The Sender Port is invalid. If you can't find a valid Sender Port, then create one.

Do these two steps in the Sending R/3 system:

1. SM59 - Create RFC destination (Type=3) pointing to the sender system itself. Verify 'Test RFC connection' and 'Test authorization (F7)'.

2. WE21 - Create a tRFC Port, and select the above RFC destination.

Use this Port in the Control record of IDOC while testing from WE19.

Hope this helps!

--- Pops V