Steps to change the source system for the data source

[#1]

Hi Experts,

Whenever I am double clicking the Info package to execute the load, the info package is not displaying and instead the error message is showing

Source system PCLNT200 is incorrect; not possible to load data.

Actually source system name is QCLNT100. Now if we change the source system name from PCLNT200  to QCLNT100 for this data source, then the problem will be resolved.

Can you guide me the steps to change the source system name for the data source.

Thanks,

Suresh.

[former_member227168 · Accepted solution]

Hi Suresh,

Can you try to below document,

http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/70a7b233-8be5-2c10-4190-aed723af5...

Thanks,

Ram's

[Former Member · Accepted solution]

Hi Ram,

Thanks for your reply and the document...

I am expecting the steps to change source system for some data sources not for all.

Can you guide me with the steps for the same.

Thanks,

Suresh.

[RamanKorrapati · Accepted solution]

Hi Suresh,

first we need to maintain logical mappings(BDLS,
SM59) between required source and bw system.

check table - RSLOGSYSMAP

Tx - RSLGMP to change logical mappings.

Later you can replicate data source from source to bw and activate data source at bw side.

rest of the steps you might be known at bw side.

At which environment your facing this issue?

Quality or dev?

Thanks

[Former Member · Accepted solution]

Hi Ram & Phani,

Thank you very much to your help.

Kind Regards,

Suresh.