SID Table Master Data

[Former Member]

Hi,

I have created a time dependent InfoObject and loaded the data using flexible load. I dont see the SID table being created for this InfoObject. I mean I dont see the corresponding X table.

I was under the impression, whenever you load master data with attributes a SID table will automatically be created. Isn't this correct?

When will the SID table be created?

Thanks,

Ace

[Former Member]

Hi,

Small doubt here -> are you loaded Master data or Trans. data?

Look the below details if you loaded Master data.

The SID table is generated when a characteristic is activated. With one exception :When a characteristic is defined as exclusively as an attribute. The SID keys are automatically generated by the system when master data is uploded.

• We can always see SID table info. in the /BIC/S or /BI0/S table not in 'X' table. X table is only generated when atleast one time-independent attribute is defined as a Navigation attribute.

Hope this will be helpful.

Regards,

KS.

Message was edited by:

K S