Reset SUM During Execution Phase

[Former Member]

Hi Experts,

We want to reset SUM because we do not need to perform the upgrade anymore.

However, the SUM is in already in the execution phase.

I run below command:

E:\usr\sap\SID\SUM\abap\bin>.\SAPup.exe reset prepare

Then it prompts error:

FATAL ERROR: System already in or after downtime, no reset possible

Please kindly advise

BR,

Fadzly Iqbal

[former_member182657]

Hi,

FATAL ERROR: System already in or after downtime, no reset possible

You could not reset the upgrade now as you're already entered into DOWNTIME phase,& the KBA you're following is suggesting reset of SUM during Preprocessing phase not for the downtime.

From the KBA  2011380 - Previous SUM not finished properly and asking for CLEAN MODULE PASSWORD 

Reproducing the Issue

Reset the SUM during the preprocessing step.

we do not need to perform the upgrade anymore.

If you do not need to perform upgrade anymore then you could restore the system with the backup which you've taken before entering into the downtime phase

Regards,

Gaurav

[Former Member]

Hi all,

Thank you very much for your responses

BR,

Fadzly Iqbal

[Former Member]

Hello Fadzly,

I trust you were able to successfully restore your system and reset the upgrade.

If so, could you please close out this thread.

KR,

Amerjit

[Former Member]

Hi Amerjit,

Yes this thread is closed.

BR,

Fadzly Iqbal

[former_member182657]

Dear Fadzly,

Please share the resolution of this thread with us & mark the thread as closed by opening the same into other tab.

Thanks,