Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Read only

Datasource Dump issue

Go to solution
former_member182997
Contributor

on ‎2014 Nov 06 6:51 AM

0 Likes
1,188

Dear Experts,

I have added three standard fields to the standard LO  DataSource and  transported in  quality.
Now when i checked the fields  the added fields are available.
Before transport i have deleted Queues, RSA7 and SETUP for the application component.
Now when i go to RSA3 and try to check the extraction for one billing document, the datasource is throwing dump.
Can you please suggest what should be done to resolve this.


I was thinking to re-transport into quality.

This is the dump message  screenshot:

Many thanks

Know the answer?

Help others by sharing your knowledge.

Answer

Need more details?

Request clarification before answering.

Show replies
Show replies
View Entire Topic
anshu_lilhori
Active Contributor
‎2014 Nov 06 7:05 AM
0 Likes

Did you clear the extraction queue and delta queue for application 13 ?

Also delete the setup table for the same application.

Also make sure that you collected the objects properly in dev.

After checking all this you can opt for re-transport.

Regards,

AL

Show replies
Show replies
former_member182997
Contributor
‎2014 Nov 06 7:11 AM
0 Likes

Hi AL,

Yes I did clear the Set up for application component 13, cleared the queues  entries for application 13   and also the rsa7 entries before transport.. Then I transported following the sequence you mentioned in my last post.

Even then I have faced with this dump today as i checked. I should mention  after I transported
i went to RSA6 and checked the fields which i added were visible. So i scheduled the setup filling so that i could check RSA3 today. But  I am messed up..


What should I do?
Should I clear all the entries you mentioned again and also delete the set up table again?

Regards!

anshu_lilhori
Active Contributor
‎2014 Nov 06 7:14 AM
0 Likes

Yes please do it once again also check in LBWE if that particular datasource is active or not ?

Check if all the requests transported successfully or not (Customizing and workbench request).

Regards,

AL

former_member182997
Contributor
‎2014 Nov 06 7:28 AM
0 Likes

Ok

I am going for all these checks after LBWE first.

But as per the message in the dump, its is telling there .

" Error occurred while transport for the object MC13VD0ITM_TAB "

I am giving you import queue screenshot of quality here:

Warning RC=4

thanks

Ask a Question