BEx setup and configuration

[Former Member]

Hello,

I've installed SAP BW 7.31 (AS ABAP) with BI-CONT add-on. However, I've got complains that BEx Web Application designer and BEx Report Designer can't connect. I've been searching for hours on help.sap.com, google, sap notes for information about what else needs to be installed but only clue I have is - Note 917950 - SAP NetWeaver 2004s: Setting Up BEx Web - it's an old note and it references older versions of BW.

I can't find on service.sap.com or other sources I mentioned official documentation about what needs to be installed in order to use BEx Web Application designer and BEx Report Designer.

Can anyone point me in the right directions, where to find right documentation for setup and configuration of BEx to enable use of BEx Web Application designer and BEx Report Designer?

Thanks,

Sasha

[arvind_doomra · Accepted solution]

Hello Sasa,

I would suggest you to please go through below help link which will guide to integrate BW with EP.

http://help.sap.com/saphelp_nw70/helpdata/en/25/5AEE4242217076E10000000A1550B0/frameset.htm

Please go through Note 937697 as this will guide you to various check related to integration.

I could find a good document for the same issue, please check this as well.

http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/b0a5216a-349c-2a10-9baf-9d4797349...

Regards,

Arvind

[Former Member · Accepted solution]

Thanks!

I glanced docs Arvind recommended, it seems to be the right path to go and enough information for brain to chew for a while.

This is all I needed for now, I will mark this question answered.

Again, thank you all.

Sasha