Approve button missing for MDG M Workflow

[#1]

Hello All,

I am trying to set up email notifications for the standard workflow in MDG-M.

I used a standard SAP document attached to work.

Unfortunately, this did not work. So i reverted back all the steps and deleted the BRF+ Z application which calls this step.

http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/c059adc5-65f7-2e10-36ab-81eb43f53...

And Now my actual standard 86 workflow is also not working. This was working perfectly fine with last status of material as 'Final Check Approved'

I am able to create material, but after refresh 'Approve' or 'Reject' buttons are missing which were visible earlier.

The materials are in 'Changes to be executed' status only.

I am not able to proceed further in approving/rejecting

Please give hints on this.

Thank you,

Shaila.

[Former Member]

Please share a screenshot of your current BRF+ table decision tables.

[Former Member]

Hello Abdullah,

Thanks for your response.

can you please tell me which change request type's DT screenshot.

However i am attaching my MAT01 BRF+ screen.

please let me know for further info.

Thank you,

Shaila.

[Former Member]

Hello All,

I could see some info in the Worflow logs.

PF the scree n below.

please let me know if i can get any hints.

In my previous workflow, there was a workitem Id visible when trying to open the workflow logn.

Any pointers please,

Thank you,

Shaila.

[Former Member]

Hi,

check transaction swi6

bus object - bus2250 and put in your change request number.

you should find more information over there.

[former_member331416]

Hi,

Incase if you do not see the approve/reject buttons when creating new material, i suggest to do the following.

1. Run the SWI6 as mentioned earlier by Tommy and check if an entry exists for your change requests. if yes, then the workflow is correctly triggered and check at what step, the workflow has stopped and why based onthe logs of workflow.

2. if no entry exists for SWI6, i assume , the workflow is not triggerred. in such as case, cross check if everything is correctly configurated as below.

3. Check if the correct workflow is assigned to the change request type.

4. Check if the type linkage is active. Process modeling->Worfkflow->Activate type linkage. when u search for BO, BUS2250, you need to see an entry with type liknage as active for CREATED event.

If you double click on it, you need to see reciver fm is SWW_WI_CREATE_VIA_EVENT_IBF and the reciever type FM is USMD_WD_REVIEVER_TYPE and the LINKAGE ACTIVATED flag is SET.

5. Check if the workflow is active. Try to reactive the workflow using PFTC.

6. The configuration guide for the material master data spectifies few steps during set up. Recheck if everythig is correct as per th document.

7. Check if the services for workflow are active using SICF.

Hope any of these steps are helpful. All the best!

[Former Member]

Hello Kishore,

Thank you for the steps.

I have rechecked the options mentioned by you, but still the issue exists. The swi6, does not show me any information about the worklfow. it says - 'there is no workflow that has already been worked with this object type.'

The activate type linkage is set to created for BUS2250 with flag checked. Receiver type is same but receiver type is USMD_WF_RECEIVER_TYPE.(WF not WD)

let me know any other path where i can check if the workflow is correct assigned ?

Thank You,

Shaila.