Sampling Procedure

[#1]

Hi, ALL

Please explain me the detail steps for through out cycle of sampling procedure in QM.

Pls revert Urgent.

Thanks in advance,

Vishal

[Former Member]

Hi,

You can create Sampling procedure through trx QDV1.

But let me know, in which scenario you are going to use Sampling Procedure.

Best of Luck,

SADAN

[Former Member]

Hi,

We want to do the inspection of incoming materials which are comes in bulk quantity. So for that perpose we want to do the sampling inspection for respective material.

Pls explain the detail steps for this scenario.

Thanks,

vishal.

[Former Member]

Hi Vishal,

As you have explained in this thread is accurate even through proceed as follows,

T.Code QDV1

Assignments:

Sampling Type: fixed sample

valuation mode: manual valuation

Inspection points: w/inspection points

next screen

control chart Type Nil

Sample:

size 1

frquency : 1

I don't know whether it will much helpful for you but you definitly will come to close of your scenario.

Best of Luck

SADAN

[Former Member]

Thanks,

Am able to create ans assign the sampling procedure to maerial. But at the time of result recording system gives one msg, charactiristic result cannot be recorded for inspection lot.

whats the solution for it.

Pls revert.

Vishal

[Former Member]

Hi,

1.Whether you are inspecting with task list or material specification

2.Where you have assigned Sampling Procedure

3. Whether you are assigned MIC

Regards

SADAN

[Former Member]

Hi,

1) Yes, am using task list

2) Am assing sampling procedure in material master in inspection type.

3) Yes am assign Master inspection characteristic in routing and task list(QP01)

Pls revert.

vishal

[Former Member]

Hi,

Set indicaor "sampling procedure" in the MIC

System will ask you assign sampling procedure at the MIC Level in the inspection.

Don't assign Sampling procedure at inspection type level in the material master.

following indicators should be set at inspection type level

inspection with task list, check charac, automatic assignment.

pl generate new inspection lot after above settings

Regards,

SADAN