Reference operation set

[Former Member]

Dear all,

for one materail i am trying to creat PRD order

order type XXXX is mainatined with refernce operation set slection in OPL8

and refernce opration set is already created in CA11

validity is ok

system is throwing following Mssg

while creating PRD order

No default value mainatined for op.generation for order type XXXX (materail YYYYYY)

Regards

kumar

[former_member196398 · Accepted solution]

Kumar,

System is unable to find a valid Referance Operation set, for Production order. Various reasons can be

1. Order quantity not within the Lot Size Validitiy of the Referance Operation set.

2. Referance Operation set "Status" and "usage" problem, not valid or not relevant to production.

3. Referance Operation set must have got created with valid from today, but the order may be exploding the PP-Master data for a past date based on the basic start and finish date of the order.

Please check these parameters...there is no need to maintain OPJG. OPJG should be maintained if you want to allow order creation with default a single operation, in the event of system not able to find a valid routing.

Regards,

Prasobh