Phantom Assembly Req

[#1]

Dear Gurus,

I am having 1 Prdod Order with 2 phantom Assembly.

But system is showing Requirement of 1 Phantom Assembly in md04 .

what could be the reason ??

Ishwar

[Former Member]

Bom Explosion With Phantom Assemblies:

1. You need to maintain the special procurement key for the phantom Assembly

in the MRP 2 View of the material master

2. If a Bom item is a phantom assembly , the dependent reqmts of the higher

level assembly are directly passed to the components of the phantom

assembly skipping the phantom assembly.

3. Planned orders/ Purchase requisitions are created for the components of the

phantom assembly.

4. We can override the Phantom Assembly Setting by defining in SPRO --->

Define Explosion Types so that MRP Creates Procurement Propasals for the

Phantom Assembly itself.

ie We can Swith off the Phantom Assembly Settings.

This settting need to be defined in the BOM Item details screen in the Basic

Data Tab Page under MRP Area.

So check in your Bom whether switch off phantom assembly is defined.

Regards,

nandha

[Former Member]

Special procurement 50 & switch off phantom assembly is not ticked

Still for Phantom Assembly its showing requirement.

Any other reason...

[Former Member]

Ishwar,

Is it requirements or reservations? In case of production orders this should be reservation not requirements. I think you might have changes special procurement type after creating production orders.

Please re-run the MRP for the header part with planning mode 3 from MD02. And check. Also check whether you have define in special procurement type in BOM item data like 60.

you can run MRP in simulation mode to verify this if do not want any new updates.

Please revert us after MRP run.

Regards

TAJUDDIN

[Former Member]

Dear ,

Its generating requirement for Phantom Assembly .

All other settings for Phantom Assembly are mantain "Explosion type" field blank, and also that "Phantom Item" check box is activated. For 1 phantom assembly it is showing as requirement & for other one its not .

Message was edited by:

Ishwar A Jamgaonkar

[Former Member]

Have you run MRP for the for the header with planning mode 3. Re-run MRP and revert us, If still requirements comes then we can think from other angle.

Regards

TAJUDDIN

[former_member196398]

Ishwar,

Please check in the order components overview and let us know if the phantom item check box is activated for both the Phantom assembly you are taking about.

Regards,

Prasobh

[Former Member]

Dear Prasobh ,

Phantom Item Check Box is Activated

Ishwar

[former_member196398]

Ishwar,

I would suggest you to manually delete the planned order and then run MRP for the Phantom assembly and let us know how it goes. Also you have not mentioned whether this materail has got a PIR on its own.

Regards,

Prasobh

[Former Member]

Dear Taj,

I have re-run the mrp for header with planning mode 3.

still requirement is coming for 1 Phantom Assembly.

Regards,

Ishwar