what is minimum basic configuration for sending data using EDI

[Former Member]

does anyone have basic configuration steps for EDI? I wanted to make sure the confiuration i have done is correct

~Suresh

[former_member460168]

Hi Suresh,

If your are sending the EDI Document using Message Control you have to configure message control using the transaction vk01.

1. Configure the Partner Profile (WE20)

2. Configure the Port (WE21)

3. Create the Application Document and propose the output type created in the VK01 transaction

send your mail id i will send the Configuration Document.

[Former Member]

hi satish,

send me the document @ [email protected]

thanks

~Suresh

[Former Member]

Hi,

Hope you are doing fine. Just wanted to know if it is possible to send me the EDI configuration steps documents? My email ID is [email protected]

Thanks

Dammah

[Former Member]

Satish,

Could you please send me the same documents to [email protected] ?>

Thanks,

Chandra

[p291102]

Hi,

Pls go through this link it may helps u .

http://www.erpgenie.com/sapgenie/docs/advanced_guide_to_edi_configuration.doc

Thanks,

Shankar

[Former Member]

Hi Satish,

Could you please email me the same at [email protected]

Thanks a lot. I would surely reward points.