SAP Script : Image problem

[Former Member]

Dear Friends,

I am working on Check, it is working fine.

Now My requirement is, If the net Amount is more than 50,000. I should populate second signature.

So, I have created other window with second signature and in Script editor.

I wrote

/: IF &REGUD-SWNET& GE 50000

/: BITMAP .........

/: ENDIF

But it is not working. when I remove the condition both signatures are poping up. I dont know where I am doing mistake.

1) Should I put '50000.00' or '50,000' or without inverted commas just 50,000

2) rugud-swnet field contains comma and decimals, so it is making any problem.

3) I have tried even using &REGUD-SWNES&, but this field contains ****50,000.

Please advice me. Also advice me, when should we use inverted commas and when should not.

Thanks & Regards

Venkat.

[Former Member]

Try

/: IF &REGUD-SWNET& GE '50000'

/: BITMAP .........

/: ENDIF

[Former Member]

Did you try this:

IF &REGUD-SWNET& GE '50000'

[Former Member]

Hi Nag & Sridhar,

I got it !! Thanks for your suggestions.

I just put

regud-swnet ge ' 50,000.000'

with 18 charecters between inverted commas.

Sridhar you are right, first time I tried with 2 decimal points.

Nag, I tried your suggestion as well, But that was not working.

Anyway... Thank you very much, I am closing this thread and alloting points.

Thanks & Regards

Venkat

Message was edited by: venkat Kumbham

[sridhar_k1]

Try

IF REGUD-SWNET& GE '        50,000.00 '

Total length between the single quotes should be 18 chars and adjust the decimal places according to ur requirement.

Regards

Sridhar

Message was edited by: Sridhar K

[Former Member]

Thanks Nag & Sridhar for your replies.

However as per sridhar suggestion, both signatures are poping-up even if regud-swnet is less than 50,000.

please advice me further.

Thanks

Venkat

[Former Member]

Hi,

Declare a variable similar as type c, lets say <var>.

Now assign <var> = amount.

condense <var>.

now try cheque value gt <var>.

Reward points if helpful.

Regards