Getting error while try to open SAP system from GUI

[#1]

Hi All,

When I try to open any SAP system from GUI I am getting below dump error message. Please suggest on this.

Thanks  & Regards

Surender

[former_member194094]

Hi Surender,

Is it a general user issue or are you the only user facing that issue ? Does the error occur right after you enter user/password ?

From the GUI session status bar, I see " Memory Low. leave the transaction before taking a break".

This looks like a improper memory configured system. I would suggest that you review your memory parameters as per the SAP note 146289.

If you already have the memory parameters set to at least the values suggested by that note, please further increase the parameters below:

    abap/heap_area_total

    abap/heap_area_dia

Hope that helps.

Kind regards,

Eric

[surender_durgam]

Hi Eric,

Thank you very much for your kind suggestions.

It is happening only for my system. I tried the same from other systems but It is working fine.

Please suggest on this.

Regards

Surender

[former_member194094]

Hi Surender,

Looks like a memory management issue. have you checked and compared the parameters mentioned previously.?

Regards,

Eric

[jude_bradley]

Hello Surender

Can you please scroll further down in the St22 dump and check if there are references to CNDP 006

in the dump?

If yes, please capture an automation trace as per note http://service.sap.com/sap/support/notes/158985

regards,

Jude