Workflow WS00000038 not complete

[#1]

Hi,

I am setting up the PR workflow WS00000038. Workflow is triggered and the first task (workitem to liberate the pr) is just fine. The correct agent is found and receives the workitem in his inbox.

But when the agent executes the workitem (Task TS00007986) and releases the purchase requision, the workflow does not continue to the next step and comes to an end.

The exits in this task in the workflow are events which are triggered (e.g. BUS2009.REJECTED, BUS2009.RELEASED)

All the following tasks already are set as general tasks, also users were assigned through customizing.

The events are visible in SWEL, why does the workflow not react to them? It reacts to the initial event BUS2009.RELEASESTEPCREATED, so the settings for event receiving in general seem to be allright in the system.

Any help is appreciated. thanks

[holger_salt]

Thank you to all that tried to help me.

Problem solved: Workflow does come to an end now and finishes in status "complete".

It seems, that the workflow customizing (SWU3) had not been fully activated. My guess would be that there is a correlation with " configure RFC destination" or "backgroundjob for event queue". Was the first workflow pattern on the system and SAP Basis had not configured SWU3 before...

[Former Member]

Hi Holger,

You don't have to use event queue if you're not expecting tens of thousands of events at once.

I always leave it out when configuring new systems for workflow.

Kind regards, Rob Dielemans