Solution manager 7.2 - Post steps and configuration document

[#1]

Hi Experts,

Although many blogs available for solution manager 7.2.

Can anyone please give me the standard document for solution manager 7.2 SP04 post steps and configurations after fresh installation.

I would appreciate all your inputs.

Thanks in advance

[former_member201054]

Thanks a lot Prakhar. Please clarify below queries as well.

if we refer the config guide, they suggested to complete installing wily and diagnostic agents only before running SOLMAN_SETUP system preparation.But mentioned nothing about SSL configuration, local SLD setup , ICM parameters, HTTPS config and P4S activation.

so all these will be covered in the SOLMAN_SETUP itself (or )we need to complete before running SOLMAN_SETUP.

If we dont configure local SLD earlier..during the SMD agent installation for the ABAP and JAVA stacks if I give the hostname of JAVA hostname..will it recognize?

I would appreciate all your inputs

Thanks in advance

[prakhar_saxena]

Hi Daniel,

It is better to configure the basic setup as soon as possible like diagnostic agent host agents etc. Normally all is taken care by solman_Setup in solman 7.2 SP04 as we have 3 different wizards now.

Configure sld HTTPS etc are part of it only.

I understand the confusion but these things you will learn by experience...for e.g. Parameters for new system can be set before hand as soon as system is installed so no need to wait till solman_Setup where it check for parameters.

Thus, please do minimum setup as per config guide and proceed with solman_setup further.

Thanks

Prakhar