Setup tables

[shalaka_golde]

What are setup tables exactly?

[Former Member]

Hi,

Access to application tables are not permitted, hence setup tables are there to collect the required data from

the application tables.

When a load fails, you can re-run the load to pull the data from setup tables. Data will be there in setup

tables. Setup tables are used to Initialize delta loads and for full load. Its part of LO Extraction scenario.

With this option, you avoid pulling from R/3 directly as we need to bring field values from multiple tables. You

can see the data in the setup tables. Setup table name will be extract structure name followed by SETUP.

Set up table names starts with 'MC' followed by application component '01'/'02' etc and then last digits of the

Data source name and then followed by SETUP

Also we can say the communication structure (R/3 side, you can check it in LBWE also) name followed by

'setup'

Open the below document page no 10 for more information.

http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/10656222-0ccb-2e10-3391-cc41996ee...