Setting up/adding system into STMS

[Former Member]

Hi,

I have 2 BI systems with different sysid and sys #, installed on seperate machines.

One is BW3.5 and the other BI7.0 both configured initially as Single system in STMS. Now i want to create a connection between them. Meaning want to make BW3.5 as Dev and BI7.0 box as Test systems and be able to do transportation. How can i go about setting up this scenario , they are both on the same network subnet.

Your help would be appreciated.

Thanks.

[Former Member]

Hi,

Steps to configure Transport Management System.

1. SE06.

Select the radio button ( Standard Installation).

and execute ( Perform-Post Installation Activities).

2. STMS

Click on Save.

The Developmnet system will then be configured as domain controller.

3. Add the Quality system to the Domain controller ( Development System).

To add ( In STMS (Dont click on save , click the button next to save )

Then Login to Development system and Approve the added system.

To Approve.

4. In STMS ....

Go with Overview --> systems.

a. Select the Qulaity system in the lIst below and

SAP System --> Approve.

b. Extras --> Distribute and Activate Configuration.

5. In STMS ....

Go with Overview --> transport routes

Configuration --> standard configuration --> Development and Production system.

Configuration --> Distribute and Activate.

6. In STMS ....

Go with Overview --> systems.

Extras --> Distribute and Activate Configuration.

Thanks,

Tanuj

[Former Member]

Hi,

SAP BW3.5 as dev:

System id# C11 with clients 000, 066, 800

SAP BI7.0 as QAS:

System id# BI7 with clients 000, 066, 001.

I want to be able to transport objects from C11(800) to BI7(001).

They are both installed and post configured ok; both on the same network. Ther is no logical system or RFC connnections defined in either one of them for each other. How are they going to see each other at application level ???

What i did:

Logged on with user other than DDIC and SAP* onto C11-000 with right previliges, SE06 - Standard installation- Perform post installation activities, message pops up saying "Do you want to reinstall the CTS? Single system settings set"---i hit YES.

STMS - noticed saved button is greyed out already (unlike in instructions) but anyway domain controller is set right.....after this i am lost..

Could you please go step by step...

thanks.

Manish