Reducing section width

[Former Member]

Hi,

I have a WEBI report in which I've used sectioning to create sparkline area charts in a table. (Please see the snapshot below).

Currently, this is the only table in the report, however, I want to place a bar graph to the right of this whole table. Meaning, a graph which is not to be sectioned off. Unfortunately, the section width stretches through the whole page, and whenever I put a graph alongside this table, it gets sectioned off.

Is there any way to reduce section width or place a whole bar chart along this sectioned table?

Thanks!

[Former Member]

Is it just on page layout? If so, change the paper size to A3 or A2.

Also, position your chart relative to the top and right edges of your block.

[Former Member]

Even on page layout, when I try to place the graph alongside it, the following happens:

Relative positioning doesn't work either. The singular graph just ends up being near the bottom on this sectioned table

[Former Member]

Ah, I see what you mean. You've create a section to enable your sparkline though so you can't just disable the section and have your graph span across it.

You might want to try using breaks in your table instead of sections.

[Former Member]

Well, I've tried that too, but the sparkline graph is just placed such that it looks a part of the table, it is just a minimized graph. If I break the table, it won't be possible to add the graph

[Former Member]

What version are you on?

[Former Member]

WEBI 4.1 Support Pack 6

[Former Member]

Hello Sakshi and Mark,

I  am also facing the same difficulty in creating my Webi report. Could you please let me know if you have found any workaround or solution to it.