Process chain error.

[Former Member]

Hi,

i have a process chain the flow is from a data source to an ODS to a Cube.

and i get this error right after the ODS activation at Update ODS object data.

Delete init. request REQU_47DAQBNNMGAW8W9HZHNPK89SX before running init. again with same selection

Message no. RSM1188

Diagnosis

If you receive message RSM1 105 as well as this message and you have chosen the automatic mode Automatic Update for the ODS object, it is probable that there are no data targets connected to the ODS object. Therefore the system cannot automatically update data after it has been activated.

System response

After each activation, the system automatically tries to update the data that has been activated to the subsequent data targets. The system generates InfoPackages for this purpose. These check whether a successful initialization has already been performed. If an initialization has already taken place the system tries to update the data with a delta request. If no initialization has yet taken place, the system tries to perform the initialization.

If no data targets have been connected to the ODS object, the system cannot update the data from the ODS object.

This system behavior does not have any effect on the consistency of the data.

Procedure

If no data targets are connected to the ODS object, switch off Automatic Update for this ODS object in the ODS object maintenance or ODS object administration.

Procedure for System Administration

SAP Note 712916 describes the system behavior above.

Please help.

Thanks,

[Former Member]

Hi,

well Kim,you are saying when you are creating the process chain you have selected one Ip and add itin the process chain

are you sure that you have selected full load IP instead delta Ip

and more thing since you have found init flag in red traffic light

my Q is do you have init Ip for the same datasource craeted other than Full Ip

if no,you can go ahead and delete the init falg ,and try

if yes please post for further analysis

cheers,

swapna.G