Problem in STMS

[Former Member]

Dear All,

Recently we have upgraded our Development and Quality System from ECC6 to EHP5.

After upgradation I have delete QAS STMS configuration from DEV system and add again as I have shift QAS server to another server (Host name changed)

QAS is added sucessfully. I have "check"  all three Connection Test, Transport Directory and Transport Tool. All checks are Ok.

But there three component mismatch between DEV and QAS. I have installed all mismatched component in QAS. Now DEV and QAS have same component.

All transport requests automatically copied from DEV to QAS. But when I press "Adjust Impoert Queue (Ctrl+F6)"  System shows following error :

I have attached screenshot also.

Source file could not be opened

Message no. PS001

Diagnosis

An error occurred when opening the source file for reading.

  File name: R908177.DEV
  Directory: $TR_DATA
  Error code: 18

Definition of the error codes:
03   RFC system failure
04   RFC communication failure
11   invalid EPS subdirectory
12   sapgparam failed
13   build directory failed
14   no authorization
15   build path failed
16   open failed
17   read directory failed
18   read attributes failed

System Response

Transmission was terminated.

Procedure

Eliminate the cause of the error and restart the transmission.

Thanks and Regards,

Nirav

[Former Member]

Hi Nirav,

• Please check the Patch levels of DEV and QAS and confirm. with the First screenshot i am just suspecting that both systems are in different patch levels.

• for second error screen shot: Go to dev system STMS Overview > Systems> and perform the Three types of checks Connection Test, Transport Directory and Transport Tool. i thought its permission issues with Trans Dir. please let me know the findings...

Thanks

Kishore Cherukumalla

[Former Member]

Dear Kishore,

Thanks for your reply.

I have checked patch level of individual components and compare. Both the systems at same patch level. When configure STMS at that time there was a diff. in following component due to that screen shot shows diff. in compnent flag. But after that I have installed all mismatched component. But that flag is not reset.

CPRXRPM    400   22

CTS_PLUG   200   5

EA-HR_MSS  1     4

I have run all three checks from both the systems. It is OK.

Transport Requests are copied from DEV to QAS 

But when I press buttton "Adjust Impoert Queue (Ctrl+F6)",  system throws error.

Even when I refresh queue, every time it start with "QAS: Sending import Que QAS(block 1 from 33)" status. It will take newar about 15 minutes.

Thanks and Regards,

Nirav