logical Source system name changed after system copy.

[#1]

Dear All,

I have a issue.

We have the BW system BWD.

we have the source system with the name ECQ300. Recently, system copy has been done by the Basis.

and now we have the new source system with the name "SAPECQ300".

They deleted the RFC connection from old system "ECQ300" and created new connection to "SAPECQ300".

Basis team has done all the necessary tasks and the RFC connection to "SAPECQ300" is also working fine.

hence we have only left with the new source system "SAPECQ300".

My problem here is,

We have all the existing data flows based on the old source system name i.e "ECQ300". since we have connection only to new Source system now. How to replace the existing assigned Source system (ECQ300) to the new source system (SAPECQ300) ??

I have read many documents on this.. but no proper clue. could you please guide me how to handle this..???

Thank you,

Regards,

Hema Tulasi.

[former_member21257]

Hi Hema,

Usually these issues are due to a missed step during the system copy process.

Basis should have followed all steps of the relevant scenario within SAP Note 886102.

Probably best to find out if they did this or not.

Rgds,

Colum

[Former Member]

Hi Column,

Okay.

But can we change anything or any setting available in the BW side to Perform.

Since the connection is established properly.

Is there is any exact way to assign this New source system with the already existing data flows.?

Thank you,

Regards,

Hema