Issue with SLT replication

[Former Member]

Hi All, we facing the following situation while trying to perform replication using SLT -

When a table is added for 'Load' or 'Replication' using the HANA Studio, nothing seem to happen. We do not see the table appear in the 'Data Load Management' screen in the studio. We have tried to add the tables to the schema using IUUC_REPL_CONTENT t-code in SLT but that does not work either - the replication status does not get updated.

The confirguration status looks green in LTR. There do not seem to be any job failures (master/data load). What could the issue, are we missing something ?

Could this be an authorisation issue, are there any standard roles for data loads.

Your suggestions are grealty welcome. Thanks.

[Former Member · Accepted solution]

Dear Anooj,

can you also check in TCODE: SM36 if there are jobs like IUUC_MONITOR* and IUUC_REPLICATE*? You have to make sure that the jobs are active resp. scheduled. You can also check if the jobs were running in the past. Can you also verify that the secondary database connection is setup correctly in transaction SM30 via view DBCON? - There should be an entry for your HANA database. You should also check the system log via SM21 if everything is ok with the replication.

Hope that helps.

Best Regards,
Marcel

[Former Member · Accepted solution]

Thanks guys. We do not seem to have the table RS_ORDER in our system, our SLT is on SP4. In LTR we do not see any triggers or stats. The monitor and replication jobs are sucessfully completed. The problem is that once a table is selected for replication or load it does not appear Data Management screen, but the table can be found again in the load and replication selection screens.

[Former Member · Accepted solution]

RS_ORDER table can be found within HANA (not the SLT system) under your SLT schema. You can also RS_STATUS under the same schema which will show you the current status of the table.

Thanks,

Anooj