DTP Errors in Process Chain.

[Former Member]

Hello,

I am facing an issue where in process chain a DTP which takes around 50 minutes to complete almost daily fails at the last data package . Even after repeat/repair on it in process chain , it fails 2-3 times and that leads to a great delay in end time of process chain .

Till now I used to Right click on the DTP and use repair/repeat and it reloads the whole data .

If I right click on the Process chain where the DTP is located and then use the repair option , will it process that failed DATA PACKAGE only which has like 27000 records or something and turn the request green ?

I just want to save this time and please clear the doubt .

Regards,

Max

[Former Member · Accepted solution]

Hi Max,

You should search more on the error message you are receiving; this will prevent the DTP from failing over and over again...

Doing a repair will run the DTP and all the processes below it and if there are no error message, then the PC will turn green. Make sure you verify that the process chain you are correcting is not a sub chain; i mean it is not part of a meta chain...

Now if you want to do some performance tuning to your process chain, may I suggest you take a look at this blog:

Regards,

Ashvin

Message was edited by: Nanreshsing Sungkur

[Former Member · Accepted solution]

Hi Nanreshsing,

Thanks, your blog is very informative.

Regards,

Max