Change Request and Buttons missing when using custom Configuration

[#1]

Dear experts,

I'm configuring the Vendor Like UI for MDG that uses the application BS_OVP_BP and configuration BS_OVP_SP_LVC.

I deep-copied BS_OVP_SP_LVC into a new one ZK_BS_OVP_SP_LVC and did no changes at all.

When the system is configured to use the original SAP configuration BS_OVP_SP_LVC everything looks OK:

and the Buttons and the Change Request section appear properly

The issue comes when I flip the configuration for the application to my newlly copied one:

in this case the actual webdynpro configuration opens, but the Buttons and the Change Request section are missing.

Is there anything I can do to have my configuration work properly and see the buttons and the CR section?

Am I missing something?

Thanks in advance,

Boris

[Former Member]

Hello Boris,

Did you solve this issue?

Even we have the same requirement of removing the CR_Section from the OVP application of MDG -material.

The requirement has no lean UI which needs to be displayed, Only one single UI which do not have the CR_SECTION itself and everyone have the same UI.

The issue is the buttons are missing when i hide the UIBB of CR_SECTION.

Is there any solution for this?

Thank you in advance.

Shaila.

[michael_theis]

Hi Shaila,

one task of the CR section is controlling the buttons. Therefore it is not recommended to remove the same. The CR is always a part of master data governance!

Best regards

Michael

[Former Member]

Hi Michael,

Thank you for your response.

So do we have any solution to atleast hide the UIBB for change request activity of 'create' ?

Regards,

Shaila.

[Former Member]

Hi Michael,

Can you please check my thread http://scn.sap.com/thread/3469202 for a different issue.

Thank you,

Shaila.