Change Request and Buttons missing when using custom Configuration

[#1]

Dear experts,

I'm configuring the Vendor Like UI for MDG that uses the application BS_OVP_BP and configuration BS_OVP_SP_LVC.

I deep-copied BS_OVP_SP_LVC into a new one ZK_BS_OVP_SP_LVC and did no changes at all.

When the system is configured to use the original SAP configuration BS_OVP_SP_LVC everything looks OK:

and the Buttons and the Change Request section appear properly

The issue comes when I flip the configuration for the application to my newlly copied one:

in this case the actual webdynpro configuration opens, but the Buttons and the Change Request section are missing.

Is there anything I can do to have my configuration work properly and see the buttons and the CR section?

Am I missing something?

Thanks in advance,

Boris

[former_member193063]

Hi Boris,

Refer the below link;

http://scn.sap.com/thread/3392023

Thanks

Nikhilesh

[Former Member]

Thank you for your reply Nikhilesh,

Unfortunately, in my case the Workflow is not yet triggered... I get that on the initial screen and I cannot even submit the request to the workflow as the button Submit is missing. Also the CR Description cannot be specified. I believe this is a different problem.

Regards,

Boris

[praveenkumar_kadi]

Boris,

Two things you may need to check if not already checked.:

1. MDG Config for action s to display on the screen.

Typically all those buttons are configured in MDG under below scetions  Define actions and step types

2. The UI Zconfiguration you created - basically you may need to check going to OVP config and in the section all the way down - toolbar scema, where you have degfault buttons assigned to that UI. check visibility etc.

Thanks

Praveen

[Former Member]

Hello Praveen,

I checked those settings, but nothing there is related to using my copied configuration.

As I mentioned before, everything works just fine when using the standard SAP configurations like BS_OVP_SP_LVC, BS_OVP_SP or BS_OVP_SP_VL

If I copy any of them and set the system to use the new one, it also works, but misses the Change request section. I can't seem to find a solution to this, so I opened an OSS message.

Let's see where that takes us.

Regards,

Boris