Classes as BOM Items ;multiple values ;multiple components

[#1]

https://blogs.sap.com/2012/05/22/classes-as-place-holders-components-in-super-bom/comment-page-1/#co...

According to the introduction of this article,I did some tests based on your blog.

MaterialMYCARClass（200/300）CL_COLOURCL_ENGINECL_EXHAUSTVariantCT_COLORCT_ENGINECT_EXHAUSTVariant Value01-RED01-120001-EXHAUST- 102-BLUE02-150002-EXHAUST- 203-Black03-180003-EXHAUST- 3ComponentsCOLOR-REDENGINE-1200EX-EXHAUST-1COLOR-BLUEENGINE-1500EX-EXHAUST-2COLOR-BlackENGINE-1800EX-EXHAUST-3

I set the feature to allow multiple values.

I tried to use cu50 to select multiple property values, but did not expand the corresponding multiple component materials.

In addition, I also tried to allocate multiple different component materials with the same 200 classification and the same characteristic value. I hope to bring out multiple different materials when cu50 selects the same characteristic value, but I failed

ClassCL_COLOURVariant CT_COLORVariant Value 01-REDComponents COLOR-RED COLOR-RED-002

Please experts to help me analyze

Can you tell me why?

How to implement these two scenarios?

thank you!

@ritesh.dube

[GnanaGiri014]

Hi,

Can you please change your configuration profile settings in Cu42 from Plan/Prod Order to order BOM and try simulation in CU50.

I see you have plan/Prod Order...

[Xiaoguang]

After modification, no components can be brought out.

When I clear this field, an error is reported.

Entry does not exist in T418 (check entry)

Message no. 00058

Diagnosis

Input values must be defined in Table T418. The value or values ' ' are not specified in this table.

When I maintain K in this field, the error is as follows:

Item category K not allowed here

Message no. CL073

Diagnosis

The item category that you enter here defines the item category of the component that is to replace the class in the BOM.

In accordance with the object type concerned, a component can only have specific item categories. Item category K, which you entered, cannot be used for this class.

[GnanaGiri014]

you can maintain the Res.Item Category both in Class or in BOM item level. Normally the Data is copied from Class to BOM item data if it is maintained in the class. If you don't maintain in class level then you have to maintain it in the BOM item Data Level.'

Key Message is "you need to make sure the indicator exist in BOM item data tab".