Terminating debugger session window

[rainer_hbenthal]

Hi,

sometimes the debuger session window is not closed after program end. As far as i remeber there is a command like /h to release the debugger window from the actual session and closes it.

Of course i can switch to that window and close it via x, put sometimes its faster to have a shurtcut.

I tried several / commands, but none of them worked as desired. So can ynoyone tell me the command to do that?

[rainer_hbenthal]

Hi,

sometimes the debuger session window is not closed after program end. As far as i remeber there is a command like /h to release the debugger window from the actual session and closes it.

Of course i can switch to that window and close it via x, put sometimes its faster to have a shurtcut.

I tried several / commands, but none of them worked as desired. So can ynoyone tell me the command to do that?

[GauthamV]

> sometimes the debuger session window is not closed after program end. .
> 

Yes, sometimes you have to come out of the session to end the debugging mode.

Did you try /n or /i ?

[rainer_hbenthal]

/n just goes to the root without closing the window, /i closes both

[GauthamV]

I am working in ECC 6.0 and /i is perfectly working for me.

Not sure about other versions.May be you can try that /hx in other versions.

[rainer_hbenthal]

This is my scenario:

i'm in the editor, setting a breakpoint and invoking the report. Debuger pops up, after pogram termination the debuger window keeps open in the background while i'm back in the editor.

/i closes both the editor and the debuger, if these are the only sessions i'm asked if i really want to log off.

/hx closes the debuger window only

[GauthamV]

If i do the same these are my results.

/i closes both the editor and the debugger, and takes both sessions to SAP easy access screen.

/hx doesn't have any effect at all,still remains in debugging mode.

[Former Member]

Hi,

Yes it will not come out till u completely come out of the particular transaction where u r debugging.

You can try by /n.

Mostly if u donot require at all the ...

Than you can stop the transaction or EXIT.

Regards

Arbind

[Former Member]

Hi Rainer,

to close the debug sessione when the transaction ending, you have to start any debug and than you have to go to "Settings" -> "Changing Debbugger Profile/Settings" and set flag "Close Debugger after 'Continue'(F8) and Roll Area end"

Regards

Mara

.

[gayathri_jayajeevan2]

/hx is used to cancel the debugger session explicitly. And the other option is as Maria mentioned, setting "Close Debugger After Continue‘F8’ And Roll Area End".