Whats the correct way to write the flow logic of a screen in which a table control has been created...??
PROCESS BEFORE OUTPUT.
MODULE modify_table.
LOOP AT tc_li_itab WITH CONTROL tc_li INTO wa_tc_li.
MODULE populate_tc.
ENDLOOP.
*
PROCESS AFTER INPUT.
LOOP AT tc_li_itab.
MODULE read_tc.
ENDLOOP.
MODULE process.
is this correct or should is use 'process' module before looping through table ??
PS: I have done processing on table control like adding new lines,selecting all,deselecting all, through push buttons in the 'process' module..
Bluesky
