STOP Command

[Former Member]

Hi All,

I have a small issue like in the ECC 6.0 i am using "STOP" command.It is syntactically correct.But when i did the extended program check for this program.It is giving me error like "STOP statement is obsolete in OO context".

Which statement i should use Rather than STOP which will execute the same function like "STOP".

This is very urgent.Please.I will reward you points.

Thanks,

Swapna.

[Former Member]

Hi

STOP ia absolete in ECC 6.0

make use of flag and check the flag and exit

regards

Shiva

[Former Member]

Hi,

Try to use CHECK with condition.

If statement is true it will go ahead else it will stop that block.

[Former Member]

Hi

STOP ia absolete in ECC 6.0

make use of flag and check the flag and exit

regards

Shiva

[Former Member]

Hi swapna,

i tried stop statement its working in ECC 6.0......

use CHECK FLD IS INITIAL.

OR USE

SY-SUBRC EQ 0.

Regards,

V.balaji

[Former Member]

Swapna,

Even though its obsolete, you can use it still if its an executable report.There is no command relacing STOP command.

If u are using STOP in selection-selction screen (not in loop and not in FORM) then EXIT has same effect.

Otherwise go for flag.

Thanks Arjun

[Former Member]

Hi,

Yes STOP command is obsolete.

So, use flags and check it at the start of every sub-routine/event where u want to stop the execution, based on the condition.

Reward if helpful.

Regards,

Ramya