Regarding transaction vf01

[Former Member]

Hi,

I am using Trasaction vf01 to create a billing document, I have chaged the user exit RV60AFZZ , when I have put one debug poing in RV60afzz , but , when I am creating the billing document, it is not going to above user-exit.

Please help me in debugging the above one,

points will be awarded sure..

thanx,

siddivinesh.Jogu

Edited by: Siddivinesh Jogu on Jan 30, 2008 11:41 AM

[Former Member]

Hi,

I am using Trasaction vf01 to create a billing document, I have chaged the user exit RV60AFZZ , when I have put one debug poing in RV60afzz , but , when I am creating the billing document, it is not going to above user-exit.

Please help me in debugging the above one,

points will be awarded sure..

thanx,

siddivinesh.Jogu

Edited by: Siddivinesh Jogu on Jan 30, 2008 11:41 AM

[SantoshKallem]

create one project in cmod and assign that exit in that project and activate the project.

try to assign that exit in some project, if it is assigns to some other proj it will give the info in status bar

regards.

santhosh reddy

reward if useful

Edited by: Santhosh Reddy on Jan 30, 2008 11:47 AM

[Former Member]

Make sure that you have activated the project.

Regards,

Nageswar

[Former Member]

Hi,

How to find out wherther the user exit is included in any project or not. ?

regards,

vinesh.

[Former Member]

Hi siddi,

U r using the USEREXIT not customer exit, if u r using customer exit then u need the project. So, u changed the USEREXIT by getting the access key. First put a hardcoded break-point and activate it.after activatting, execute ur tcode.

i hope it may work,

regards,

ravi shankar reddy

Edited by: Ravi Shankar Reddy S on Jan 30, 2008 11:52 AM

[Former Member]

Hi Jogu,

Good!

Use the udate debugging. befor saving give /h then activate the update debuging. it should go to that place if u set break point.

thanks,

Sunil