Community
Application Development and Automation Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Read only

Question about icm/HTTP/mod profile param

Go to solution
tim_alsop
Active Contributor

‎2013 Jul 23 3:29 PM

0 Likes
922

We are considering using the icm/HTTP/mod parameter to provide URL transformation and/or HTTP header manipulation, but we are not sure which release of NetWeaver / ABAP this parameters is included in. I read somewhere that it was included in NetWeaver 7.10 but I am not very sure what implications this has ? Does it mean we can install a certain level of fixes for SAP NetWeaver 7.0 and get the same functionality as included in NetWeaver 7.10 ?

Thanks,

Tim

1 ACCEPTED SOLUTION
Read only

Go to solution
Former Member

‎2013 Jul 23 10:37 PM

0 Likes
777

I guess you mean the icm/HTTP/mod_<xx> parameter? According to help.sap.com it was introduced in NW702 and is available in any release after that. Looking at NW700 and NW701 kernel patches it looks like the parameter was never backported to earlier releases.

2 REPLIES 2
Read only

Go to solution
Former Member

‎2013 Jul 23 10:37 PM

0 Likes
778

I guess you mean the icm/HTTP/mod_<xx> parameter? According to help.sap.com it was introduced in NW702 and is available in any release after that. Looking at NW700 and NW701 kernel patches it looks like the parameter was never backported to earlier releases.

Read only

Go to solution
tim_alsop
Active Contributor
In response to Former Member

‎2013 Jul 24 7:40 AM

0 Likes
777

Thank you. We have been able to test on NW 7.00 and 7.02 and found that 7.00 didn't contain the support for this param, but we were not sure how to check if there was a patch available for older releases.

Thanks,

Tim