Processing Routine Error

[Former Member]

I am issuing the output for the document using my output type ZXXX

Th eoutput type is configured and connected to my program and a routine is sepecified as well in config.

In the program I have specified the routine as :

FORM ENTRY USING return_code us_screen.

code logic.

endform

I am getting the error in the output issue that the routine entry could not be found in the program.

The control is not reaching my program.

any idea?

regards

[Former Member]

Perform Entry is dynamically invoked.

where can i put the breakpoint?

[Former Member]

1.make sure that all ur programs in active

2.put a break point at <b>PERFORM ENTRY</b>in debuggung mode....

and check....

Ramesh.

[Former Member]

Perform Entry is dynamically invoked.

where can i put the breakpoint?

[Former Member]

Hello,

if you are triggering output via rsnast00 program ,then set a break-point at the forma routine.:FORM PROGRAMM_AUFRUFEN USING ...

This routine calls TNAPR entries. :TNAPR-RONAM & TNAPR-PGNAM field should provide you further details.

Hope this helps.

Mark points if helpful.

Thanks.

[Former Member]

Goto Tcode NACE and after selecting the application give ur message Type ZXXX

and check in processing routines what is the form name and program name (if present )

confirm this ..

if program name is there then double click on that program name and set the breakpoint in the code based on entry.

<b>like there might be a case in nace where i may refer to the same program with different entry name as

entry1

entry2

entry3</b>

and like that.

now the program will process this as

<b><i>FORM ENTRY1 USING RETURN_CODE US_SCREEN. "entry1

CLEAR RETURN_CODE.

SCREEN = US_SCREEN.

PERFORM PROCESSING USING US_SCREEN.

IF RETURN_CODE NE 0.

RETURN_CODE = 1.

ELSE.

RETURN_CODE = 0.

ENDIF.

ENDFORM.

FORM ENTRY2 USING RETURN_CODE US_SCREEN."entry2

.............

ENDFORM.

FORM ENTRY3 USING RETURN_CODE US_SCREEN.

.............

ENDFORM.</i></b>

so u need to look here and then put the breakpoint here on the entryn where n = entry number .

just check this ..

now u need to search the entry and place the breakpoint there

if form routine is there with a program then it has to stop.

and in the output mode for medium how is this going as a mail or printout or fax etc..

regards,

vijay