DEAR FRIENDS,
I HAVE TO GET DATA FROM BSEG TABLE ACCRODING FOLLOWING SELECTION DATA IN WHERE CONDITION MENTIONED IN BELOW QUERIES.
I HAVE DATA IN TEMP_VBRK BUT AFTER EXCUTING FOLLOWING QUEREY I AM GETTING ITAB_BSEG INITIAL. NO DATA.
WHILE SAME SELECTION DATA PUTTING IN SE16-BSEG,THEN I AM GETTING REQUIRED DATA.
I HAD TRY SOME DIFFERENT WAY ALSO BUT STILL GET NO DATA.
PLEASE SUGGEST POSSIBLE WAY OF SOLUTIONS.
**********************************
LOOP AT TEMP_VBRK.
READ TABLE ITAB_VBRK WITH KEY VBELN = TEMP_VBRK-VBELN.
IF SY-SUBRC EQ '0'.
TEMP_VBRK-BUKRS = '54'.
*TEMP_VBRK-VBELN = ITAB_VBRK-VBELN.
TEMP_VBRK-GJAHR = '2007'.
TEMP_VBRK-GSBER = 'MKTG'.
TEMP_VBRK-HKONT = '2711001'.
MODIFY TEMP_VBRK TRANSPORTING BUKRS GJAHR GSBER HKONT.
ENDIF.
ENDLOOP.
*getting data from bseg
IF NOT TEMP_VBRK[] IS INITIAL.
SELECT BUKRS BELNR GJAHR SHKZG GSBER WRBTR PSWSL VBELN HKONT KUNNR
ZFBDT FROM BSEG INTO CORRESPONDING FIELDS OF TABLE ITAB_BSEG
FOR ALL ENTRIES IN TEMP_VBRK
WHERE BUKRS = TEMP_VBRK-BUKRS
AND BELNR = TEMP_VBRK-VBELN
AND GJAHR = TEMP_VBRK-GJAHR
AND GSBER = TEMP_VBRK-GSBER
AND HKONT = TEMP_VBRK-HKONT.
ENDIF.
Bluesky
