Community
Application Development and Automation Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Read only

Output Condition Problem

Former Member

‎2010 Apr 16 7:08 PM

0 Likes
432

Hi Experts,

A new output 'ZA00' is created in NAST with VSTAT = 0 by the t-code VA02. Later on, User makes some changes to the order then hit save. This time it does not fulfill the output requirement, so requirement routine return 4 (don;t trigger output). This action causes the removal of ZA00 output from NAST table. It should stay there. Please advise.

Thanks,

Hi,

Your question itself has the answer. As you are telling requirement routine is stopping the o/p to be triggered, check why you have that routine assigned and the logic in side the routine. Either you can change the code in the routine as per your requirement (Set sy-sucrc = 0 for your conditions) or remove the routine from T-code NACE for that output if not required.

Thanks,

Vinod.

Reply
1 REPLY 1
Read only

vinod_vemuru2
Active Contributor

‎2010 Apr 17 11:30 AM

0 Likes
398

Hi,

Your question itself has the answer. As you are telling requirement routine is stopping the o/p to be triggered, check why you have that routine assigned and the logic in side the routine. Either you can change the code in the routine as per your requirement (Set sy-sucrc = 0 for your conditions) or remove the routine from T-code NACE for that output if not required.

Thanks,

Vinod.