Module Pool : Table control

[Former Member]

Hi,

In a table control o/p, supose I have 5 records in the table.Now I want to add 2 new records in the same.So I have to add 2 new editable line in which anyone can enter data.

My problem is that in such condition, if I am giving 2 values in 2 rows, then the last one is always available.How can I get all the records?

It seems to be there must be any loop on table control.But I am unable to find it out.

Please advice me.

[Former Member]

Are you using table control wizard???

If yes it will be very helpful to you!first tell me using table control wizard?

[Former Member]

can you clearify more you isuue is not understandable

[Former Member]

I have a table control which is displaying 5 record from a database table ZTABLE.

Now if I press a 'ADD' buton in the same screen, then 2 blank EDITABLE row is inserted in the table control.

Now my requiremnet is that I may enter data in both 2 rows/or in 1st row/in 2nd row.

Now in the PAI of the screen, I am getting always the last row value in the workarea ZTABLthough I want all the edited records. How can I proceed?

[Former Member]

Are you using table control wizard???

If yes it will be very helpful to you!first tell me using table control wizard?

[Former Member]

No I am not using Table control wizard.

In the table ciontrol screen, I am giving 2 values in 2 row.s. That is my question that they must be stored in a table? But in PAI, I am getting the workarea value.How can I find the Table name and the Loop?

[Former Member]

are you updating this value in internal table or not?

how can any structure can get two value ?

means you will have to use interanl table to store value ,

and table conrol is using single work area ,

so during loop -endloop in pai it will pass this value to work area,

so but obvious you will get last value!!

so check with your internal table with both values

Regards,

Alpesh

[Former Member]

Check the following link

http://www.sapdev.co.uk/dialog/tabcontrol/tc_basic.htm