how to set error message inside the loop...module pool

[Former Member]

Dear all,

Am creating Table Control without wizard. In that i am looping the values, that is, Once if i entered 5 digit values means, 12345-08... the values should be stored in z-table like this 12345,12346,12347,12348 . That is 5-8 it as to update in z table. for this i createdloop at itab and inside that i written a code to count the value and all. and also its clearly updating the value in ztable too. now i want to know, if once again i entered the same value means, like 12345-08.. it as to show error messge.I dont know how to set the condition with error message inside the single loop .... Its all comes under module pool program.

Thanks,

Santhosh.R

[Former Member]

Dear all,

Am creating Table Control without wizard. In that i am looping the values, that is, Once if i entered 5 digit values means, 12345-08... the values should be stored in z-table like this 12345,12346,12347,12348 . That is 5-8 it as to update in z table. for this i createdloop at itab and inside that i written a code to count the value and all. and also its clearly updating the value in ztable too. now i want to know, if once again i entered the same value means, like 12345-08.. it as to show error messge.I dont know how to set the condition with error message inside the single loop .... Its all comes under module pool program.

Thanks,

Santhosh.R

[Former Member]

If i understood your doubt, here goes the answer.

LOOP AT itab INTO wa_itab.  " This is your loop
  l_tabix = sy-tabix. "l_tabix receives the line of the loop
  READ TABLE itab WITH KEY itab = wa_itab.  "itab is the same tab of your loop 
  IF sy-subrc EQ 0 AND l_tabix NE sy-tabix.    "Here the sy tabix have the value of the read table.
*     Here you do your error treatment.
  ENDIF.
ENDLOOP.

Explanation: When you are looping your internal table, you use a READ TABLE to see the already recorded registers. If the read table finds one register (sy-subrc EQ 0) and the this register is not the one of the current line (l_tabix NE sy-tabix). It means you have a duplicated register.

Maybe there is someway easier to do this, but this is what i thought now.

I hope this was your doubt hehe.

Thales Schmidt

[kesavadas_thekkillath]

Hi,

What i will do is...if its a z table i will creaate one more field like "Combination Key". For each record of 12345,12346,12347,12348 i will store 12345-08 against it . So that its easy to do such manipulations.

It can be also done through looping logic but lots of effort is needed.

[Former Member]

hi,

as only the last digit(5-8) will change, write a select statement on Z table write a where condition as below.

select matnr from ztab into itab where (matnr like 1234*)

then looping through the table itab will not take much time and if duplicates ar efoung while looping, raise message.

Regards,

KIshore