Error in Receving System

[Former Member]

Hello Friends,

I have configured 2 systems sender and receiver I have a custom table and and custom idoc segment and custom message type I am able to successfully send the Idoc generated from the sender side but on the receiving side when i see the idoc i get error 56 with the message" Partner profile inbound not available" , can u guys tell me how to solve this error. I was successfully able to distribute the model in sender system.

I appreciate your cooperation.

Thanks.

Regards,

Sohail

[Former Member]

Hi,

Please check the inbound partner profile (WE20) in the receiver system.

And ensure is configured properly for the incoming IDoc. Also ensure the incoming IDoc Control Record is matching the inbound partner profile setup.

Regards,

Ferry Lianto

[Former Member]

Hello Ferry

What do you mean by " incoming IDoc Control Record is matching the inbound partner profile setup" can you please eloborate on that ! I have the custom message already setup in Inbound Parameter of the partner profile.

Thanks.

Regards,

Sohail

[Former Member]

Hi,

Each IDoc has control record (EDIDC) and data record (EDIDD).

In control record, the sender system will populate the type info (such as basic type, message type, etc) and partner information for recipient and sender information which should match with the inbound partner profile setup in receiving system.

The recipient and sender information contain port, partner, and partner type.

Regards,

Ferry Lianto

[Former Member]

Hello Ferry Lianto ,

I looked deep into the control recods in we05 and found out that the receving system the port was missing can you tell me how to solve that problem?

Regards,

Sohail Mansuri

[former_member187255]

Sohail,

Pls check tcode WE20 and make sure u assigned the right port for the Inbound message type.

Hope this helps you...

[Former Member]

Hi Sohail,

You need to specify the receiver system in the sender's outbound partner profile (WE20). Go to Outbound Options tab and enter the receiver port.

Regards,

Ferry Lianto

[Former Member]

Hello Ferry Lianto,

I tried it and still the port is coming blank in the Idocs in we05 , but now when i tried it with the we19 to post the idocs it worked fine and the data got posted? So can you please give me your personal mail so that I can send you screenshots of the error and config so that you can point out where exactly I am making a mistake.

thanks,

Regards,

Sohail Mansuri

[Former Member]

Hi Sohail,

Please update your BC (profile) with email address ... then I will email you.

Regards,

Ferry Lianto

[Former Member]

Hello Ferry Lianto ,

I have updated the Business Card details.

Thanks.

Sohail Mansuri