Dynamic Field - Exception

[Former Member]

Hi,

I need to raise exception in a select statement. Is it possible,

I need to check whether a particular field is present in a table rather than a value. If not, need to raise error,.

select single (P_stat)

from K810008

into (p_Stat)

where gjahr = p_year and

perde = p_period.

if sy-subrc <> 0.

MESSAGE e000 WITH text-s05.

endif.

The following gives a dump cos the field name is given wrongly, i cant capture it.

[Former Member]

Hi,

Try this:

Make sure you pass the relevant field name in CAPS to P_STAT before the select query

select single (P_stat)

from K810008

into LV_STAT " LV_STAT is a variable of type ANY

where gjahr = p_year and

perde = p_period.

if sy-subrc 0.

MESSAGE e000 WITH text-s05.

endif

Hope this helps

Regards

Shiva

[Former Member]

Hi,

After you get a dump goto transaction ST22 and find the class exception of the dump you are getting.

For example

if the class exception is cx_division_by_zero.

Then code like the below,

data: error type ref to cx_division_by_zero.

try.

select single (P_stat)
from K810008
into (p_Stat)
where gjahr = p_year and
perde = p_period.

catch cx_division_by_zero into error.
endtry.

Now the reference variable error will hold the dump error which can be displayed.

Use the relevant class exception instead of cx_division_by_zero.

Regards,

Vikranth

[Former Member]

Hi Krish,

Rather than catching the error after receiving it, you should look before your query in table DD03L if the field exists in this table!

Example of code :

SELECT * FROM dd03l
  WHERE tabname = 'K810008' AND
               fieldname = p_stat.
IF sy-subrc = 0.
SELECT SINGLE (p_stat)
  FROM K810008
  INTO (p_stat)
  WHERE gjahr = p_year AND
        perde = p_period.
ENDIF.

Best regards!

Samuel

[Former Member]

SELECT * FROM dd03l
  WHERE tabname = 'K810008' AND
               fieldname = p_stat.

This would work only if p_stat is a single field either valid or invalid. But since its dynamic and if you are concatenating two fields, even if both fields are valid, the above select would fail.

[Former Member]

Hi,

we can catch the exception with the following code:

TRY.

select single (P_stat)

from K810008

into (p_Stat)

where gjahr = p_year and

perde = p_period.

RAISE EXCEPTION TYPE CX_SY_DYNAMIC_OSQL_SEMANTICS.

CATCH CX_SY_DYNAMIC_OSQL_SEMANTICS.

WRITE:/5 'Exception caught'.

ENDTRY.

Regards,

Ashok