Debugging inside a loop

[Former Member]

Hi,

In a loop I am having 250 record ( eg : yr 2005/02 to 2013/08 ) .I am getting error in the year 2013 ( from 2013/01 to 2013/08) . Only from 2013 i need to debug instead going all the 200 records. How can i debug only the selected record(2013) in my loop while debugging.

[Former Member]

HI,

If you know the number of entries before the line desired in internal table, you can skip those number of lines by going to break/watchpoint tab and keep a breakpoint inside your loop. So it stops for the iteration skipping the number of line mentioned.

If you do not know the number of lines before your desired line, create a watch point with condition where you can specify a value for a variable and cotrol will be stopped once that variable is populated with the value specified.

[Former Member]

Hi

Set a watchpoint for year (I don't know the name of the variable) = 2013

Max

[RaymondGiuseppi]

Look at online help for New Debugger, Control, Watchpoints

Regards,

Raymond

[Former Member]

Hi Meenakshi,

You can create a watch point for variable SY-TABIX for respective internal table.

Cheers,

Varun Sahu

[former_member202818]

Hi Meenakshi,

Use watch point, with the free condition, date(4) = '2013'.

Press enter. Then F8, each time when the condition satisfies the control will stop at the particular line.

Or, suppose you want to set this condition for a break point... follow this..

Regards

Sreekanth

[jitendra_it]

Hello,

Once you set Breaking Point inside a loop. Go to Break./Watchpoints tab , enter the number of iterations in Skip column section for which control should not halt.

Now control will directly jump to next one(Skip + 1) and halt there once you press F8.

[Former Member]

HI Meenakshi,

  The way sreekanth told is correct please try in same manner.

[Former Member]

HI,

If you know the number of entries before the line desired in internal table, you can skip those number of lines by going to break/watchpoint tab and keep a breakpoint inside your loop. So it stops for the iteration skipping the number of line mentioned.

If you do not know the number of lines before your desired line, create a watch point with condition where you can specify a value for a variable and cotrol will be stopped once that variable is populated with the value specified.