data 0 when insert into table

[Former Member]

the ITAB is

DATA: BEGIN OF BESTAND OCCURS 100,

BWKEY LIKE MBEW-BWKEY,

WERKS LIKE MSEG-WERKS,

MATNR LIKE MSEG-MATNR,

CHARG LIKE MSEG-CHARG,

*(DEL) endmenge like mard-labst, "Bestand zu 'datum-high' XJD

ENDMENGE(09) TYPE P DECIMALS 3, "Bestand zu 'datum-high' XJD

*(DEL) anfmenge like mard-labst, "Bestand zu 'datum-low' XJD

ANFMENGE(09) TYPE P DECIMALS 3, "Bestand zu 'datum-low' XJD

MEINS LIKE MARA-MEINS, "Mengeneinheit

• values at date-low and date-high "n497992

endwert(09) TYPE P DECIMALS 2, "n497992

anfwert(09) TYPE P DECIMALS 2, "n497992

*(DEL) soll like mseg-menge, "XJD

SOLL(09) TYPE P DECIMALS 3, "XJD

*(DEL) haben like mseg-menge, "XJD

HABEN(09) TYPE P DECIMALS 3, "XJD

SOLLWERT(09) TYPE P DECIMALS 2, "n497992

HABENWERT(09) TYPE P DECIMALS 2, "n497992

WAERS LIKE T001-WAERS, "Wהhrungsschlssel

END OF BESTAND.

in my ztable i declare insread of

(09) TYPE P DECIMALS

menge that is the reson i get 0.00

if yes?

what is the element needed for this

<b>(09) TYPE P DECIMALS</b>

[Former Member]

Hi Liat,

Remove the suffixes after variables. This doesn't make sense with TYPE P declarations.

Replace all statements with out suffixes. Save and activate and Rerun the program.

Instead of this ENDMENGE(09) TYPE P DECIMALS 3

write as <b>ENDMENGE TYPE P DECIMALS 3</b>.

Thanks,

Vinay

[Former Member]

Vinay

i talk about data elemnt in se11

thanks

[Manohar2u]

Do you want to have decimals (0.00) instead of 0.

or 0 instead of 0.00, for data type P it is controlled from program attribute Fixed point arithmetic

You set the program attribute Fixed point arithmetic.

Regds

Manohar

[Former Member]

where can i set it

[Manohar2u]

In Prgram attributes, will be under EDIT menu.

Regds

Manohar

[Former Member]

se38>prg>attribute->edit

[LucianoBentiveg]

Try with VGWRT.

Regards.

[RichHeilman]

How many decimal places to you want in your ztable? If you want three, then just use the MENGE_D data element.

Regards,

Rich Heilman

[Former Member]

rich i use this data element but i get 0.00 instead of numbers

bcs of that i asked.

[Manohar2u]

Yes, but hope its an custom program right??

Regds

Manohar