BAPI_NETWORK_COMP_ADD error

[Former Member]

Hi

I am assigning a variable size material component with item category R to a network activity using BAPI_NETWORK_COMP_ADD.

However, the BAPI is calculating incorrect variable size item Qty (ROMEN) even though the correct formula key, units and sizes are paased. The material master conversion factor is also maintained correctly for the material component.

Any possible suggestions or applicable notes for correcting the error is welcome.

Regards

Srikrishna.

Edited by: Srikrishna D on Jul 27, 2009 1:51 PM

[Former Member]

Hi ,

Check this.

DE ROMEN

____________________________________________________

Short Text

Quantity of variable-size item

Definition

Quantity of variable-size item, which the system calculates from the sizes entered. If you wish you can enter a variable-size item formula for the. calculation.

The quantity of the variable-size item shown is per piece (PC)

Procedure

If you change a field that affects the calculation of the variable-size item quantity (for example, size or formula), the system only recalculates the quantity if you delete the existing quantity first.

To do this, delete the contents of the Qty Var-sz item field.

Examples

Size 1: 200

Size 2: 300

Size unit of measure: MM

Variable size item unit: SQM

Calculation of variable-size item quantity:

A = Size 1 * Size 2

A = 200 MM * 300 MM

A = 0,06 SQM

--> The variable-size item quantity for each piece is: 0.06 SQM

Dependencies

The value calculated is required in MRP, in order to calculate the total quantity of the raw material requirement for the component.

If 10 pieces are required for the component, the variable-size item quantity is: 10 * 0.06 SQM = 0.6 SQM.

[Former Member]

Hi,

My doubt was not answered.You just told the functionality not the solution of the problem that I am facing

Regards,

Srikrishna

[Former Member]

closing the thread