Inquiry about issues stopping replication flow.

[#1]

Hello Community,

I have been facing an issue with a replication flow that I have been trying to stop for a week, but without success. I would like to know if anyone has experienced something similar and could help me understand the possible causes of this problem.

I have tried several solutions, but the flow remains active. Could you suggest what else I might check or if there are any specific steps I should follow to resolve this issue?

I appreciate any guidance or advice you can offer.

Best regards

[FlavioMacedo]

Hi All,

so as I mentioned on previous comment. I did open a ticket with SAP and they acknowledged the issue and will add the fix. here is their response: "We plan to implement a fix in the DIG component to address the inconsistency found in the DIG API response."

The workaround (works 90% of the time) is to after you press the "Stop" button, wait few minutes for the job be stopped in the background. Then press the "stop" button again. You will see an error message saying something like "Replication flow cannot be stopped...." Close the message, refresh the data monitor job. The status should be refreshed. 

hope this helps some of you. 

[FlavioMacedo]

I am experiencing the same problem. RF just sits there with "Stopping" status and nothing happen. Can't restart, can't pause or anything after that. The only option I had (and by no means is a solution) was to delete and recreate the RF. I couldn't wait as we were on deadline project. I have open SAP ticket to see what they say. Will post here if I find solution. 

[AnkurGoyal03]

This problem recently started in our production environment and it's really strange that we cannot stop or kill the stuck job. I have raised an incident with SAP and hoping that they will resolve it quicker. I'll let you know once we have the solution is place.