Data flow conversion Issue

[Former Member]

Hi experts,

I am facing an issue while converting a data flow from 3.5 to 7.0 version.

The concerned flow is between Datasource 2LIS_04_P_MATNR and Infocube 0PP_C02.

As you can see on the above screen. the isse is located in the transformation between Datasource and Infosource.

When I check the hole transformation. I am getting this error screen.

So I can understand that my routines (in update rules) contain some errors.

When I check one of them. I am getting the error:

"E:The data object "TRAN_STRUCTURE" does not have a component called "SI_FREI"."

When I check the generated routine. The field is declared and existing (please refer to below code)

I also added the field in the source fields of rules (91 and 92). But I still get the same error.

I found out some threads in SDN with my issue. But no one really helped me.

Thanks for your advices.

Amine

[former_member182470 · Accepted solution]

Hi,

Step1 : Just for the time being, please revert back to 3.X version of your datasource.

Step 2: Take a back-up of your routines which are there in the update rules

Step 3: Debug your routine to check everything is OK

Step 4: Try to migrate you data flow again

http://scn.sap.com/docs/DOC-11763

Regards,

Suman

[Former Member · Accepted solution]

Hi Suman,

Thanks for the answer.

How can I revert back to 3.X version?

Thanks,

Amine

[Former Member · Accepted solution]

Hi Amine

Hope you doing well in your new role. To revert back please see the link below.

http://scn.sap.com/thread/3208541

Regards

Sunny

[Former Member · Accepted solution]

Hi Sunny,

It's being a while i didn't saw your contributions, It's a pleasure to hear form you again

Amine

[Former Member · Accepted solution]

Hi Amine

Ya it's been a while got busy with few projects. And good to see your posts too. I will be intouch and all the best for the future.

Regards

Sunny

[Farouk_ · Accepted solution]

Hello Suman,

How can I debug the Routine in Step 3 and check for consistency.

Regards,

Sherif

[former_member182470 · Accepted solution]

Hi Sherif,

You can simply hardcode BREAK-POINT. in the routine. When you run the data load, it will take you to debugging screen.

Regards,

Suman

[surendra_p]

Hi Amine,

For Migration Data flow from BW 3.5 to BW 7.0 you are getting some errors.

Please go through the following link you get some information.

http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/608c815f-178d-2e10-1a90-dd067ec5f...

Regards

Surendra

[anshu_lilhori]

Hello Amine,

Were you able to resolve this issue by any chance ? If yes,then please share the solution.

I am also facing this issue and tried whatever i could, but all efforts in vain.

Regards,

AL

[Former Member]

Hi Anshu,

Unfortunately, i couldn't solve it back in that time. I am not anymore on that project.

I will try to contact my colleagues, if i have any answer i will let you know.

Cheers.

Amine