order release error

[#1]

hi,

while releasing the order below error appear please help.

@5D\QWarning@ %00000000001   Work center APAC-L in plant  has no cost center @35\QLong text exists@ Costing

while doing confiration below error appear

ck 282, work center has no cost center.

reg.nsm

[Former Member · Accepted solution]

Hi NS,

In work center costing TAB (APAC-L) you need to maintain cost center. While creation of master data for work center you can assign the cost center for the above work center.

Hope it helps you and doubts please revert me.

Regards,

Madhu.G

[Former Member · Accepted solution]

Hi,

done the same.

now while doing confirmation the error is Document number for general ledger document could not be determined

reg. NSM

[Former Member · Accepted solution]

Hi,

Please consult your FI consultant for the same.

Regards,

Alok Tiwari

[Former Member · Accepted solution]

ok. thanks.

i want to create a order for minimum lot size 500 after MRP run and also the order should create in multiple of 500. please help

[Former Member · Accepted solution]

Dear,

Specify rounding value as 500 in the MRP view. It will generate planner order of 500 if the requirement is below 500 and then in the multiples of 500 if the requirement is more than 500.

Regards,

Nitin Kurhade

[Former Member · Accepted solution]

thanks Nitin.

[Former Member]

Hi,

Check the workcentre APAC-L in tcode CR03. Cost center must be assigned in workcenter costing tab with active validity date.

Regards,

Dharma

[Former Member]

Hi,

i have checked validity date it is from 01.01.2012 to 31.12.2012

reg. NSM

[Former Member]

Hi,

validity date 31.12.2012 is expired. Extend the validity date to 31.12.2013.

Regards,

Dharma

[Former Member]

Hi,

i have changed the date now the error is Document number for general ledger document could not be determined

[Former Member]

Hi,

Please assign a cost center in the work center APAC-L in the costing tab of it.

Regards,

Alok Tiwari