FPM Forms Buttons Missing while initiating from Master Data Application(HRPAO_PAOM_MASTERDATA)

[#1]

Hi Experts,

We want to use Master Data Application(HRPAO_PAOM_MASTERDATA) to initiate OM FPM forms.

While we launch the form from HRASR_DT or from Process Start Application (asr_process_start_ovp) we have exactly same form that is getting launched. We have 'Check' button to check the form for error before sending and also have 'Send to Expert' button if there is any error in the form.

But from Master data application 'Check' and 'Send to Expert' buttons are missing and also the Name displayed on top of the form is different from what we have configured. Is there any way to get these feature while launching the FPM Form from  HRPAO_PAOM_MASTERDATA?

Adding few screenshot for clarity.

1) Master Data Application(HRPAO_PAOM_MASTERDATA) is used to initiate Create Org unit Form

2) Check and Send to expert Buttons are missing and the Name of the Form is also different

3) This is what we get when we initiate the Form from HRASR_DT and Start Process Application (asr_process_start_ovp). Is it possible to get the same screen if we launch the FPM Form from HRPAO_PAOM_MASTERDATA?

Regards,

[ChrisSolomon]

Why are you using "HRPAO_PAOM_MASTERDATA" to launch your OM/PD forms/processes? You can use the same "start application" (process execute) as your PA processes to do the same thing but it will launch correctly. It will look at your process configuration and should see that you have it set as a "PD" process and know how to launch/handle correctly from there.

[sahirn]

Hello suman kurian,

Check if you have assigned the process(in target application parameters) correctly in lpd_cust.

Hope this helps.

Regards.

[Former Member]

Hi Sahir,

Thanks for the reply.

Our Processes is already configured in LPD_CUST and the correct form is getting opened up from Master data application.

Our issue is with the top portion of the FPM forms where some buttons are missing and Form Name is different. I think that portion is getting defaulted by Master data application. Dont know if there is a fix for this issue 

Regards,

Suman