CO718 Error message

[#1]

Hi,

pl. try the below scenario.

1. Do a prodn confirmation for a prodn order such that a Post processing error is generated.(COGI)

2. Perform TECO of the prodn Order. While doing so u get a Confirmation promt that ''Order no.xxx.There are still reprocessing records. Set order to technically complete?.''

If u2018Nou2019 or u2018Cancelu2019 is pressed, the CO718-Error comes. But when yes is pressed, u2018Tecou2019 takes place, even though CO718 message is marked as u2018Erroru2019.

My Requirement : under any circumstances i shoul not be able to TECO a prodn order if there are reprocessing records.

regards.

[Former Member · Accepted solution]

run OPK4 for your plant / prod.order type

and try to set a tick in a box "Termination for Incorrect Goods Movts" (General individual entry TAB)

you can also tick the "Termination for Incorrect ActCosts"

[Former Member · Accepted solution]

hi,

iam sorry, but this wont help.

regards

[Former Member · Accepted solution]

Dear Rishi,

Check by using this User Exit, PPCO0001 Application development: PP orders

or else check in OPJB by converting the warning into error message.

I dont think it's possible to achieve the same using System status or user status.

Check and revert back.

Regards

Mangalraj.S

[rupesh_brahmankar · Accepted solution]

Dear,

Please refer OSS Note 185645 - Technical completion despite incorrect goods movmnt.

Regards,

R.Brahmankar

[Former Member]

Try customising order status in BS42.