CCUNDO T_CODE

[Former Member]

DEAR GURUS,

HOW TO MAKE USE OF THIS T_CODE (CCUNDO). I AM NOT ABLE TO MAKE OUT WHAT THIS DOES. I HAVE TRIED CREATING CHANGE NOS. THEN CHANGING THE ATTACHED OBJECTS USING THE CHANGE NO.

LATER I TRIED TO UNDO THE CHANGES USING THIS T_CODE.. BUT IT ALWAYS GIVES THE MSG. "No changes found for change number ".

I AM USING ECC6.0.. THIS T_CODE WAS NOT AVAILABLE IN 4.6C

CAN ANYONE HELP?

[daniel_huber · Accepted solution]

Hi Abhishek,

this undo functionality works for the following objects:

- Bill of material

- material master (planned changes only)

- Variant configuration objects (object dependencies, configuration profile, variant table)

There is a BADI ECM_UNDO to extend support for additional (customer) objects or enhance the standard behaviour.

Please reward points if answer is helpful.

Best regards, Daniel