webDynpro not working on ECC6.0 SR2

[Former Member]

Dear experts

we have installed new ECC6.0SR2 after that we Start working on webdynpro

its shows page cannot be displayed

can you tell me how to solve this problem and how to Configure Webdynpro after new installation

regards

krishna

[Former Member]

Dear experts

we have installed new ECC6.0SR2 after that we Start working on webdynpro

its shows page cannot be displayed

can you tell me how to solve this problem and how to Configure Webdynpro after new installation

regards

krishna

[Former Member]

Hi Krishna.

I was facing the same problem few months before. At first, You have to activate ICF services. Check OSS note 1088717. Another thing that has to be done is to configure FQDN - see [Fully Qualified Domain Names (FQDN)|http://help.sap.com/saphelp_nw70ehp1/helpdata/en/67/be9442572e1231e10000000a1550b0/frameset.htm]. Complete initial configuration settings are described in [Web Dynpro ABAP Configuration|http://help.sap.com/saphelp_nw70ehp1/helpdata/en/67/be9442572e1231e10000000a1550b0/frameset.htm], but for me turning on ICF services and setting FQDN were sufficient. I have not configured anything about ICM, SSO nor View Designer

Regards,

Adrian

[Former Member]

HI Murthi,

I am also facing the same problem(page can't be displayed) from last 1 month in my IDES system,I had been approched some of the insatlation people but noboday help me.

Please tell what are the steps i have to configur for ides system.

Please help me.

Thanks&regards

Krishnareddy.B